Eigenschaften
- Case Type:
Fired
- Patrone:
44 Magnum
,44 Special
- Versandgewicht: 0,136kg
- Versandhöhe: 28mm
- Versandbreite: 28mm
- Versandlänge: 53mm
- UPC: 815145022899
Artikel-Nr.: 749002527
Herst.-Nr.: PH-44SM
815145022899 Die Wilson Case Holders halten die Hülse rechtwinklig zur Schneidfläche, um das Trimmen sowie das Innenhals-Reaming, das Entgraten des Hülsenmundes und das Entfernen von Militärcrimp zu ermöglichen. Standard Pistol Case Holders erfordern, dass die Hülsen fest in den Halter eingeklopft werden, um die Hülse sicher zu halten, aufgrund der geraden Wandkonstruktion. Wir empfehlen, wenn verfügbar, Q-Style-Halter für Pistolenkartuschen.Lieferzeit ca. 14-21 Tage.
Die Wilson Case Holders halten die Hülsen perfekt im rechten Winkel zur Schneidfläche, um präzises Trimmen sowie das Innen-Nacken-Reamen, das Entgraten der Hülsenmündung und das Entfernen von Militärcrimps zu ermöglichen.
Mit den WILSON TRIMMER CASE HOLDERS bist du bestens ausgestattet, um deine Hülsen präzise zu bearbeiten und deine Schießergebnisse zu verbessern!
Fired
44 Magnum,
44 Special
Used to make Makarov Brass 27.06.2015
I used this Wilson holder to turn 9mm luger into 9mm Makarov. Used a drill to speed things up. Obviously, you size to Makarov after you trim to about 18mm (exact trim to length in your load book).
Works great. Creates a mess of course. I had to create a system where I would hammer out the piece of brass by using a brass punch. One quick tap to the holder would knock it out. It's not like the rifle brass which can be knocked out quickly. Wilson warns of this in the instructions with this holder.
Works when it is used correctly 30.04.2015
I have accurately cut many cases using this without using a press. As long as the back of the cartridge extends out of the holder to where the micro-meters foot can make contact with it and the cutting bit can make contact with the case edge you are golden. This will make a consistent cut time after time as it is a set distance based on the cartridge. if the cartridge does not extend out the back of the holder your micro-meter foot will contact the holder and will cut the case too short. My only gripe is that the holder has a tenancy to spin in the trimmer when the cutter is pressed harder to cut faster.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.