Brownells Deutschland - Einer der größten Lieferanten für Waffenteile, Büchsenmacherwerkzeug & Schießsportzubehör Deutschland

SINCLAIR INTERNATIONAL
SINCLAIR STUCK CASE REMOVAL TOOL

749013572
We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
30.9 30.9 1 EUR
Artikel-Nr.: 749013572
SINCLAIR INTERNATIONAL Stuck Case Remover Wir haben dieses praktische Werkzeug entwickelt, um das uralte Problem der Wiederlader zu lösen: das Entfernen einer Hülse, die im Kalibriermatrizensatz feststeckt. Dies passiert, wenn der Rand der Hülse während des Abwärtsbewegung abreißt und den Hülsenkörper in der Matrize zurücklässt, ohne etwas zum Herausziehen zu haben. Das Sinclair Stuck Case Removal Tool ermöglicht es dir, die feststeckende Hülse aus jeder Standard-Kalibriermatrize zu entfernen, ohne das Risiko einer Beschädigung der Matrize. Entferne einfach die Matrize aus der Presse und drehe den Entzündungszapfen heraus, bis er nicht mehr im Zündloch ist. Spanne die Matrize in einen Schraubstock und 'gewinde' das Zündhütchenloch und das Zündloch mit dem mitgelieferten Bohrer und Gewindebohrer, damit du den Hauptkörper des Werkzeugs in das Loch schrauben kannst. Wenn du die Kapselschraube mit einem Standard-3⁄16"-Sechskantschlüssel festziehst, zieht das Werkzeug die Hülse ordentlich aus der Matrize.
30.9 EUR 0 30,90 € *
Nachbestellt, Lieferzeit ca. 4-12 Wochen aus dem Großlager.

Eigenschaften

Versandgewicht: 0,126kg Versandhöhe: 13mm Versandbreite: 102mm Versandlänge: 152mm

Artikeldetails

Made in USA



We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
Newsletter