EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Rock Island 1911s EAA / Tanfoglio Witness' with LPA/Bomar style rear sights (EAA Super Sight)
Die perfekte Montage für dein Leupold DeltaPoint Pro!
Der LPA-LOW LEUPOLD DELTAPOINT PRO SIGHT MOUNT von EGW ist die ideale Lösung, um dein Rotpunktvisier sicher und einfach zu montieren. Hier sind einige wichtige Informationen:
Produktbeschreibung
Die EGW Rotpunktvisiere sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Lauf nach vorne gerichtet). Der Schwalbenschwanz hat eine progressive Taperung, die die Installation erleichtert. Entferne einfach die hintere Visierung deines Gewehrs und ersetze sie durch die EGW-Montage, um dein Leupold DeltaPoint Pro, JPoint, Redfield Accelerator oder Optima Rotpunktvisier zu montieren. Du kannst die Montage jederzeit abnehmen und deine hintere Visierung wieder anbringen. Montagematerial ist im Lieferumfang enthalten.
Montageanleitung
- Entferne die hintere Visierung*
- Installiere die EGW Sight Mount im Schwalbenschwanz
- Ziehe die Set-Schraube fest (falls zutreffend)
- Platziere das Rotpunktvisier auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Montage erleichtert die Entfernung und schützt das Rotpunktvisier vor Loctite)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs an
Die Modifikation deiner Feuerwaffe kann die Herstellergarantie ungültig machen. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden. Für Schäden oder Verletzungen, die aus unsachgemäßer Installation oder Nutzung dieses Produkts resultieren, wird keine Haftung übernommen.
Diese Montage passt nicht auf:
- Rock Island 1911s
- EAA / Tanfoglio Witness' mit LPA/Bomar-Stil hinteren Visierungen (EAA Super Sight)