This mount is NOT a drop in part and will require fitting. EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. EGW products should be installed and checked by a qualified and competent gunsmith. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail after checking for fit Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount fits: Firearms with oversized Novak cut dovetails. This mount is made .007"" larger than a standard Novak cut and will require fitting.
Entdecke die OVERSIZED NOVAK 0.007" VORTEX VIPER/VENOM SIGHT MOUNT!
Diese Montage ist kein Plug-and-Play-Teil und erfordert eine Anpassung. Die EGW Rotpunktvisiere sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Lauf nach vorne). Der Dovetail hat eine progressive Taper, die die Installation erleichtert.
Produktbeschreibung
- Entferne die hintere Visierung deines Gewehrs.
- Installiere die EGW Sight Mount im Dovetail, nachdem du die Passform überprüft hast.
- Ziehe die Set-Schraube (falls zutreffend) fest.
- Setze das Rotpunktvisier auf die EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Montage erleichtert die Entfernung und hält Loctite vom Rotpunktvisier fern).
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf.
- Ziehe die Montageschrauben mit 15 in/lbs an.
Enthaltene Schrauben:
- 2 Button Head Cap Screws - Für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - Für Burris FastFire und Docter Sights
Die mit diesem Mount gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel zur Installation. Eine Modifikation deiner Feuerwaffe kann die Herstellergarantie ungültig machen.
Dieses Produkt sollte von einem qualifizierten Gunsmith installiert und überprüft werden. Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemäßer Installation oder Verwendung dieses Produkts resultieren.
Kompatibilität
Diese Montage passt auf Feuerwaffen mit oversized Novak cut Dovetails. Diese Montage ist um .007" größer als ein Standard-Novak-Cut und erfordert eine Anpassung.