EGW red dot sightsare meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: USP Compact (rear sight cut depth is .200"" instead of .160"") USP Expert USP Elite VP9 VP40 P30 P30L P30SK HK45 HK45C
Optimiere deine Zielgenauigkeit mit dem H&K USP LEUPOLD DELTAPOINT PRO SIGHT MOUNT!
Der EGW Red Dot Sight Mount ist speziell dafür konzipiert, von links nach rechts installiert zu werden (mit dem Lauf nach vorne gerichtet). Die Schwalbenschwanzführung hat eine progressive Taperung, die die Installation erleichtert.
Produktbeschreibung
Entferne einfach die hintere Visierung deines Gewehrs und ersetze sie durch die EGW-Montage, um dein Leupold DeltaPoint Pro, JPoint, Redfield Accelerator oder Optima Red-Dot-Visier zu montieren. Es sind keine Änderungen an deinem Feuerwaffe erforderlich. Du kannst die Montage jederzeit abnehmen und deine hintere Visierung wieder anbringen. Montagematerial ist im Lieferumfang enthalten.
Installationsanleitung
- Entferne die hintere Visierung*
- Installiere die EGW Sight Mount in der Schwalbenschwanzführung
- Ziehe die Set-Schraube fest (falls zutreffend)
- Platziere das Red Dot Sight auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Red Dot Sight und der Sight Mount erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern.)
- Trage blauen Loctite auf die bereitgestellten Montageschrauben auf
- Ziehe die Montageschrauben auf 15in/lbs an
Eine Modifikation deiner Feuerwaffe kann die Herstellergarantie ungültig machen. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden. Für Schäden oder Verletzungen, die durch unsachgemäße Installation oder Nutzung dieses Produkts entstehen, wird keine Haftung übernommen.
Hinweis:
Diese Montage passt nicht für:
- USP Compact (Tiefe des Ausschnitts für die hintere Visierung beträgt .200" statt .160")
- USP Expert
- USP Elite
- VP9
- VP40
- P30
- P30L
- P30SK
- HK45
- HK45C