EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"
Perfekte Lösung für deine Desert Eagle Pre 2017!
Der EGW Sight Mount für die Leupold DeltaPoint Pro ist die ideale Ergänzung für deine Desert Eagle Pre 2017. Mit diesem Mount kannst du deine Zieloptik einfach und sicher anbringen.
Produktbeschreibung
Die EGW Rotpunktvisiere sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Lauf nach vorne gerichtet). Der Dovetail hat eine progressive Verjüngung, die die Installation erleichtert. Entferne einfach die hintere Visierung deines Gewehrs und ersetze sie durch den EGW Mount, um deine Leupold DeltaPoint Pro, JPoint, Redfield Accelerator oder Optima Rotpunktvisierung zu montieren. Du kannst den Mount jederzeit abnehmen und deine hintere Visierung wieder anbringen.
Installationsanleitung
- Die hintere Visierung entfernen*
- Den EGW Sight Mount im Dovetail installieren
- Die Set-Schraube anziehen (falls zutreffend)
- Die Rotpunktvisierung auf den EGW Sight Mount setzen (ein kleines Stück Papier zwischen der Rotpunktvisierung und dem Mount erleichtert die Entfernung und hält Loctite von der Rotpunktvisierung fern.)
- Blaue Loctite auf die mitgelieferten Montageschrauben auftragen
- Montageschrauben auf 15in/lbs anziehen
Die Modifikation deiner Feuerwaffe kann die Herstellergarantie ungültig machen. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden. Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemäßer Installation oder Benutzung dieses Produkts resultieren können.
Hinweis
Dieser Mount passt nicht für:
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Bitte achte auf die Unterschiede zwischen Pre 2017 und Post 2017, wenn du deine Bestellung aufgibst.
- Der hintere Regal hinter dem Dovetail bei Pre 2017 beträgt .187"
- Der hintere Regal hinter dem Dovetail bei Post 2017 beträgt .120"