Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Die perfekte Montage für dein Trijicon RMR Rotpunktvisier!
Die CZ SHADOW 2 TRIJICON RMR SIGHT MOUNT von EGW bietet eine zuverlässige und einfach zu installierende Lösung für deine Zieloptik.
Produktdetails:
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Montagezubehör: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Kompatibilität:
Rotpunktpassung: Trijicon RMR, Holosun HS507C
Diese Montage passt:
- Baby Desert Eagle (nach 2006)
- EAA Witness Elite Match
Diese Montage passt nicht: Rock Island 1911s
Installation:
Um dein Trijicon RMR Rotpunktvisier zu montieren, entferne einfach die Kimme deines Gewehrs und ersetze sie durch unsere Montage. Es sind keine Änderungen erforderlich. Du kannst unsere Montage jederzeit abnehmen und deine Kimme wieder anbringen.
Montageanleitung:
- Die hintere Kimme entfernen*
- Die EGW Sight Mount in den Dovetail installieren
- Set-Schraube anziehen (falls zutreffend)
- Das Rotpunktvisier auf die EGW Sight Mount setzen (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Montage erleichtert die Entfernung und hält Loctite vom Rotpunktvisier fern.)
- Blaue Loctite auf die mitgelieferten Montageschrauben auftragen
- Montageschrauben mit 15in/lbs anziehen
Hinweis: Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation.