Eigenschaften
- Modell:
Commander
,Government
- Waffentyp:
1911
- Versandgewicht: 0,014kg
- Versandbreite: 83mm
- Versandlänge: 146mm
Artikel-Nr.: 168000127
Herst.-Nr.: P28SC
Komplettes Set mit 11 präzisionsgeschliffenen Stiften und Plungern zur Renovierung eines bestehenden 1911 oder zum Bau eines neuen von Grund auf. Wärmebehandelt für hervorragenden Widerstand gegen Oberflächenverschleiß und eine lange Lebensdauer. Erhältlich in matt blued Kohlenstoffstahl oder Edelstahl mit natürlicher Oberfläche.Lieferzeit ca. 14-21 Tage.
Das 1911 PIN SET von CASPIAN ersetzt jeden einzelnen Pin in deiner Pistole und ist hitzegehärtet für Stärke und Langlebigkeit.
Dieses vollständige Set umfasst 11 präzisionsgeschliffene Pins und Plunger, die ideal sind, um eine bestehende 1911 zu renovieren oder eine neue von Grund auf zu bauen. Die Pins sind wärmebehandelt und bieten hervorragenden Widerstand gegen Oberflächenabnutzung für eine lange Lebensdauer.
Erhältlich in:
Das Set beinhaltet:
Das Set passt für das 1911 Government Model, Commander und deren Klone; es passt jedoch nicht für das Officers Model.
Commander,
Government
1911
Buyer Beware 27.12.2011
I bought this set of pins to finish out a 1911 build I'm doing for my wife. I ordered the Caspian Race Ready Receiver (168-100-110) for the build, so I figured I'd order this pin set since it's made by the same manufacturer. The ejector pin in this set is solid, and I think it's slightly oversize, as it bent while I was trying to install it into the ejector pin hole (yes, I had done the requisite notching of the ejector post, and there was no blocking of the hole when I looked thru it; I also should have measured the diameter of the pin against the diameter of the hole--I really think a roll pin is better for this application).
Additionally, if you decide to use the Cylinder and Slide Professional Trigger Kit (206-000-019), the hammer strut pin in this set is too large (the pin is .095 and the hole in the hammer is about .093). I reamed out the hole in the hammer, but it was still a very hard pin to drive in.
In the future, I will probably order a different set of pins. I may or may not order Caspian pins again, I haven't yet decided. The mainspring parts are all fine, as are the plunger pins and the sear and hammer pins.
I want to caveat the "Would you recommend this to a friend" question by saying I would recommend it, but I would also tell them what I experienced.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.