Eigenschaften
- Modell:
M1 Garand
- Waffentyp:
Springfield
- Versandgewicht: 0,023kg
- Versandhöhe: 5mm
- Versandbreite: 79mm
- Versandlänge: 130mm
Artikeldetails
US-Exportklassifizierung: 0A501.x

Artikel-Nr.: 100001733
Herst.-Nr.: 10021
Das belüftete Stahl-Design verändert die Zyklenzeit, indem es dir ermöglicht, das Gasvolumen im Zylinder anzupassen. Schnelle Anpassung der Belüftungsgröße mit integriertem Einstellschraube; es ist nicht nötig, Schrauben für unterschiedliche Belüftungsgrößen zu wechseln. Reduziert die Abnutzung an den Bolzenlappen, dem Betätigungshebel, dem Empfänger und der Abzugsgruppe. Verfügbar für M1 Garand und M1A.Das MA ADJUSTABLE GAS SYSTEM und das M1 ADJUSTABLE GAS SYSTEM von SCHUSTER bieten dir eine innovative Lösung, um den Verschleiß an Bolt Lugs zu reduzieren und den Aufprall auf den Op Rod zu dämpfen.
Das belüftete Stahl-Design verändert die Zykluszeit, indem es dir ermöglicht, das Gasvolumen im Zylinder anzupassen. Die schnelle Anpassung der Belüftungsgröße erfolgt über eine integrierte Schraube, wodurch das Wechseln von Schrauben für unterschiedliche Belüftungsgrößen entfällt.
Hergestellt aus Stahl mit einer parkisierten Oberfläche. Ersetzt die vorhandene Gas-Mutter ohne Modifikationen am Gewehr. Das Set beinhaltet ein Anpassungswerkzeug und eine Anleitung.
M1 Garand
Springfield
Must Have 18.05.2017
Must have part for an m1 if you want to shoot it a lot or don't reload and don't have access to surplus. I'm going to tune mine for modern 180 grain hunting loads, since that's the most common ammo I can get. Better to use new ammo too because it's not corrosive or dirty. If you don't have the tool to change the plugs out, a large flathead screwdriver will work. Set screw is a little tricky to get started, but it works well.
Hard to install Adjust Gas Plug, M1A, 24.04.2014
I bought this product a couple weeks ago to use on my Spfld Arm. inc. M1A and had trouble screwing it in a Military spec. gas cylinder...at first I thought that it was the wrong thread, but a closer comparison revealed that they were correct, just super tight....I used Krills oil on both threads and turning it a 1/8 of a turn at a time using a 1/2" combo wrench it went home....I took the weapon to the range and ran some Tulammo through it. I had to adjust (tune) the valve per instructions and the M1a operated great...it dropped the cases 2 feet away, kinda just barely making it out of the weapon.....no strain on the op rod at all...it is worth the money if you consider how much an M14 op rod cost to replace....
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.